COMPANY INFORMATION

FRONT OPENING OF SHAPER CAP

Reference drawing above to fill in fields below

A. Height in Corners:

B. Height in Center:

C. Width in Corners:

D. Width in Center:

E. Special Corner Radius (standard is 1/32"):

Cap Description:

CROSS SECTION OF SHAPER CAP

Reference drawing above to fill in fields below

NOTE: All rear openings should be 1/8" HIGHER and WIDER than front opening of die base.
You must supply a drawing for special shapes (anything not rectangle) or to describe beads (frogs).
If you require drilled and tapped holes on the front face of the shaper cap, supply a drawing and additional instructions.

DIE OPENING

Reference drawing above to fill in fields below

NOTE: The die base opening must never be WIDER or HIGHER than the rear opening of the cap.

Die Base Number:

H. Width of Die Base Opening:

I. Height in Center:

J. Height in Corners:

ADDITIONAL INFO & ATTACHMENT

Number of Caps Ordered:

Additional Comment and Information:

Attach a file of your drawing (PDF or JPG only / 4mb max):